14-6 Chapter 14
Assembly Replacement and Post-Repair Procedures
Covers
Covers
Tools Required
• T-10 TORX screwdriver
• T-15 TORX screwdriver
• T-20 TORX screwdriver
• T-25 TORX screwdriver
Refer to Figure 14-2 when performing the following procedures.
Removing the top cover
1. Remove both upper rear feet (item 1) by loosening the attaching screws (item 2).
2. Loosen the top cover screw (item 3).
3. Slide cover back and off.
Removing the side covers
1. Remove the top cover.
2. Remove the lower rear foot (item 4) that corresponds to the side cover you want to
remove by loosening the attaching screw (item 5).
3. Remove the handle assembly (item 6) by loosening the attaching screws (item 7).
4. Slide the cover back and off.
Removing the bottom cover
1. Remove both lower rear feet (item 4) by loosening the attaching screws (item 5).
2. Loosen the bottom cover screw (item 8).
3. Slide the cover back and off.
To Next Page
Loading...
Need help?
General
