1-2 Chapter 1
Service Equipment and Analyzer Options
Required Tools and Equipment
Required Tools and Equipment
The following is a list of the tools required to service your analyzer:
• T-8, T-10, T-15, T-20, and T-25 TORX screwdrivers
• Flat-blade screwdrivers — small, medium, and large
• 5/16-inch open-end wrench (for SMA nuts)
• 2-mm extended bit Allen wrench
• 3/16, 5/16, and 9/16-inch hex nut drivers
• 5/16-inch open-end torque wrench (set to 10 in-lb)
• 2.5-mm hex-key driver
• Non-conductive and non-ferrous adjustment tool
• Needle-nose pliers
• Tweezers
• Antistatic work mat with wrist-strap
• #0 Phillips Screwdriver
To Next Page
Loading...
