Chapter 14 14-39
Assembly Replacement and Post-Repair Procedures
A20 Disk Drive Assembly
Test the disk-eject function, and adjust if required.
1. Insert a diskette into the disk drive and then eject the disk.
2. If the diskette does not eject properly, loosen and then retighten the three screws that
hold the disk drive to the disk drive bracket:
a. Loosen the three screws that are readily accessible.
b. Loosen the upper-most front screw through the screw hole left empty in step 7 on
page 14-38.
c. Center the disk drive in the opening.
d. Retighten all three screws.
Reinstall the front panel and covers
1. Reinstall the top left screw under the trim strip.
2. Reinstall the trim strip.
3. Reinstall the covers. If necessary, refer to “Front Panel Assembly” on page 14-8 for help
with this task.
To Next Page
Loading...
