238 Chapter5
Language Reference
MEASure Group of Commands
Power spectral
density
reference
not
specified
or n=1
Basic,
cdmaOne,
cdma2000,
W-CDMA
(3GPP), or
W-CDMA
(Trial &
Arib) mode
Returns 24 comma-separated scalar results, in the following
order:
1. Upper adjacent chan center frequency - relative power (dB)
2. Upper adjacent chan center frequency - absolute power
(dBm/Hz)
3. Lower adjacent chan center frequency - relative power (dB)
(same as upper)
4. Lower adjacent chan center frequency - absolute power
(dBm/Hz) (same as upper)
5. Negative offset frequency (1) - relative power (dB)
6. Negative offset frequency (1) - absolute power (dBm/Hz)
7. Positive offset frequency (1) - relative power (dB)
8. Positive offset frequency (1) - absolute power (dBm/Hz)
...
23.Positive offset frequency (5) - relative power (dB)
24.Positive offset frequency (5) - absolute power (dBm/Hz)
2
NADCand
PDC mode
Returns 10 comma-separated scalar values of the pass/fail
(0=passed, or 1=failed) results determined by testing the
absolute power of the offset frequencies:
1. Negative offset frequency (1) absolute power
2. Positive offset frequency (1) absolute power
...
9. Negative offset frequency (5) absolute power
10.Positive offset frequency (5) absolute power
2
iDEN
mode
Returns 3 comma-separated scalar values of the histogram
absolute power trace:
1. Lower offset frequency − absolute power
2. Reference frequency − absolute power
3. Upper offset frequency − absolute power
Total power
reference
2
Basic,
cdmaOne,
cdma2000,
W-CDMA
(3GPP), or
W-CDMA
(Trial &
Arib) mode
Returns 11 comma-separated scalar values (in dBm)
corresponding to the total power histogram display. The values
are returned in ascending frequency order:
1. Negative offset frequency (5)
2. Negative offset frequency (4)
...
6. Center frequency
7. Positive offset frequency (1)
...
11.Positive offset frequency (5)
Measurement
Type
n Results Returned
To Next Page
Loading...
Need help?
General
