Chapter 5 239
Language Reference
MEASure Group of Commands
3
NADCand
PDC mode
Returns 10 comma-separated scalar values of the pass/fail
(0=passed, or 1=failed) results determined by testing the
relative power of the offset frequencies:
1. Negative offset frequency (1) relative power
2. Positive offset frequency (1) relative power
...
9. Negative offset frequency (5) relative power
10.Positive offset frequency (5) relative power
3
iDEN
mode
Returns 3 comma-separated scalar values of the histogram
relative power trace:
1. Lower offset frequency − relative power
2. Reference frequency − relative power
3. Upper offset frequency − relative power
Power spectral
density
reference
3
Basic,
cdmaOne,
cdma2000,
W-CDMA
(3GPP), or
W-CDMA
(Trial &
Arib) mode
Returns 11 comma-separated scalar values (in dBm/Hz)
corresponding to the power spectral density histogram display.
The values are returned in ascending frequency order:
1. Negative offset frequency (5)
2. Negative offset frequency (4)
...
6. Center frequency
7. Positive offset frequency (1)
...
11.Positive offset frequency (5)
4
NADCand
PDC mode
Returns the frequency-domain spectrum trace (data array) for
the entire frequency range being measured.
In order to return spectrum data, the ACP display must be in
the spectrum view and you must not turn off the spectrum
trace.
4
iDEN
mode
Returns 4 comma-separated absolute power results for the
reference and offset channels.
1. Reference channel − absolute power
2. Reference channel − absolute power (duplicate of above)
3. Lower offset channel − absolute power
4. Upper offset channel − absolute power
Measurement
Type
n Results Returned
To Next Page
Loading...
Need help?
General
