133
Settings
Repeating a voice announcement
If the function has been switched on and
route guidance is active, the last naviga-
tion announcement can be repeated or an
updated navigation announcement out-
put by pressing .
! Select Repeat voice announcement in the
voice mode settings.
! Turn the rotary control/push button
to switch the function on ( ) or off
().
System settings
You can configure various basic settings
on your Cascade to meet your require-
ments in the system settings.
The following possible settings are
available:
For
Audio:
• Setting for speed-dependent increase
in volume with Speed-dependent vočume
• Using Instaččation position of microphone,
you can specify whether your vehicle
is a left-hand drive or right-hand drive
vehicle.
• Setting for acoustic signal volume
with
Vočume of warning tones
• You can use Dispčay vočume to select
whether a change in volume should be
displayed in graphics format.
• Setting for the volume level of digital
to analogue audio sources with
Digitač
čeveč
• You can use Supports parking aid to se-
lect whether the audio volume is to be
lowered when the reverse gear is en-
gaged.
For
Dispčay:
• Setting display brightness with Dispčay
brightness
• Setting display colour using Cočours.
• You can use
Day/night design to config-
ure the settings for changeover be-
tween day and night design.
Other settings:
• Using
Externač device, you can specify
whether an AUX source or an external
hands-free unit is connected to the
Cascade instead of a CD changer.
• You can use
Reset functions to reset the
Cascade to the factory settings.
• You can use
Data backup
to backup the
address book data or load previously
saved data back onto your Cascade.
• You can use Direction of rotary actuator
to specify the direction in which lists
and menus are scrolled when the
rotary control/push button is turned.
7013
To Next Page
Loading...
Need help?
General
