52
Navigation mode
Unblocking a route
Once a block has been entered, it can be
removed again.
! In the Options menu, select the Bčock
entry.
! Select Yes (delete block) or No (retain
block).
Modifying route options
You can modify the route options during
navigation.
! In the Options menu, select the Route
opt.
entry.
! Select Dynamic route, Quick route, Short
route
or the avoid functions (on = ).
! In the Route Options menu, select
Ready.
The route is calculated with the new
route options.
Switching navigation announcements
on/off
You can switch navigation announce-
ments off and then back on again.
! In the Options menu, select the
Announce. entry.
! Press the rotary control/push button
to switch navigation announcements on
() or off ().
Note:
If no operator inputs are made, the
menu will automatically disappear after
a few seconds and the block will be
retained.
2074
Note:
Only one of the three settings (Dynamic
route, Quick route
, Short route) may be
active ( ) at the same time.
For more information about route
options, see “Setting the route options”
on page 33.
2075
To Next Page
Loading...
