Becker Cascade - Displaying the Volume; Settings for Left-Hand; Right-Hand Drive Vehicles; Volume for Acoustic Signals

135
Settings
Settings for left-hand/ right-hand
drive vehicles
Navigation announcements and
telephone calls/ voice mode
announcements are transmitted via
different loudspeakers. Using this
function you can specify whether your
car is a left-hand drive or right-hand
drive vehicle and therefore set the
transmission accordingly.
! Select Audio in the system settings.
! Select Instaččation position of microphone.
! Select between Right/centre and Left/
centre
(on = ).
Volume for acoustic signals
You can change the volume for acoustic
signals.
! Select Audio in the system settings.
! Select Vočume of warning tones.
! Turn the rotary control/push button
to select the required value.
Displaying the volume
You can activate/deactivate the display of
a change in volume in graphics format.
! Select Audio in the system settings.
! Select Dispčay vočume.
! Turn the rotary control/push button
to switch the function on ( ) or off
().
Note:
A setting of “0” indicates no increase in
volume.
A setting of “20” indicates the maximum
increase in volume.
7052
Note:
Only one of the two settings can be
active ( ) at one time.
Note:
A low value indicates a low volume for
acoustic signals.
7017
7018