34
Navigation mode
! Turn the rotary control/push button
to select one of the following options:
Dynamic route,
Quick route,
Short route,
Avoid motorway,
Avoid tunneč,
Avoid točč,
Avoid ferry or
Ready
! Turn the rotary control/push button
to switch the required function on ( )
or off ( ).
•
Dynamic route
The route is calculated taking into
account the traffic announcements
received.
If dynamic route guidance is active,
the routes are calculated on the basis
of the fastest route to the destination.
•
Quick route
With this setting, the route with the
shortest possible travel time to the
destination is calculated.
•
Short route
With this setting, the route with the
shortest possible distance to the desti-
nation is calculated.
•
Avoid motorway, Avoid tunneč, Avoid točč
and Avoid ferry
You can use these entries for example
to exclude ferries or motorways from
the route calculation. The Cascade
will then attempt to calculate a route
which does not contain any motor-
ways or ferries.
Saving/Deleting route options
! In the Route Options menu, select
Ready.
! Confirm your selection by pressing
the rotary control/push button .
or
! Press .
You can now start route guidance
Note:
Only one of the three settings (Dynamic
route
, Quick route or Short route) may be
active ( ) at the same time.
Notes:
• Dynamic route guidance is not possi-
ble in all countries at present.
• When new route calculations are
made with active dynamic route guid-
ance, the Cascade may request the
memory card containing the naviga-
tion data (if it is not already inserted).
Notes:
• Routes without motorways can only
be calculated for short distances (up
to 200 km depending on digitalisation
density).
•Even if
Avoid točč is selected, toll roads
(e.g. in Switzerland or Austria) will
be included in the route calculation.
To Next Page
Loading...
Need help?
General
