50
Navigation mode
Route list
You can display the route planned by the
Cascade.
! In the Options menu, select the Route
čist
entry.
A list of the roads to the destination
appears. The distance to be travelled
along each road appears after its name.
! Turn the rotary control/push button
to scroll through the list.
! Press to exit the route list.
Stopover
You can enter another destination as a
stopover during active navigation.
! In the Options menu, select the Stop-
over
entry.
! Turn the rotary control/push button
to select one of the following options:
Enter address,
Add. book,
SpeciačDest,
Point of Interest (externač) or
Rapid access
! Confirm your selection by pressing
the rotary control/push button .
•
Enter address
You can enter a complete address as a
stopover as described in “Entering a
destination” on page 27.
•
Add. book
You can enter an address book entry as
a stopover as described in “Selecting a
destination from the address book” on
page 38.
•
SpeciačDest
You can enter a POI as a stopover as
described in “Point of interest” on
page 39.
•
Point of Interest (externač)
You can enter a POI as a stopover as
described in “External points of inter-
est” on page 43.
•
Rapid access
You can enter a fast access destination
as a stopover as described in “Naviga-
tion fast access” on page 35.
Once the stopover has been selected, the
route is recalculated and route guidance
started to the stopover.
Note:
Once route guidance has started, it
takes a little while for the route list to
appear in full.
If the route list is not available due to
recalculation,
No route čist avaičabče
appears. For technical reasons, distance
information cannot be displayed for the
road currently being driven on.
2070
2039
To Next Page
Loading...
