51
Navigation mode
Deleting a stopover
If you have entered a stopover, you can
delete it before reaching it.
! In the Options menu, select the Stop-
over
entry again.
! Select Yes (delete stopover) or No
(retain stopover).
If
Yes is selected, the stopover is deleted
and route guidance to the main destina-
tion started automatically.
Blocking a route
You can use this function to block a sec-
tion of the route still to be travelled when
the next junction is reached. If possible,
the Cascade will then calculate a diver-
sion route. This may be useful if a traffic
jam or road block lies immediately
ahead.
! In the Options menu, select the Bčock
entry.
! Turn the rotary control/push button
to select the required distance to be
blocked.
! Confirm your selection by pressing
the rotary control/push button .
The route is recalculated.
Note:
Once the stopover has been reached, the
following display appears.
Route guidance to the main destination
is started automatically.
2071
2072
Note:
If no operator inputs are made, the
menu will automatically disappear after
a few seconds and the stopover will be
retained.
2073
To Next Page
Loading...
