Benelli TRK 502 Service Station Manual

2 - 17
TECHNICAL DATA
GENERAL TIGHTENING SPECIFICATIONS
The tightening torques of the different special parts or assem-
blies are provided in each chapter of this manual.
As far as concerns assemblies with multiple fastenings, in order
to prevent the risk of warping, cross tighten in successive stag-
es, until you reach the required torque.
Unless otherwise stated, the tightness torques refer to parts with
clean, dry threads.
Parts must be at ambient temperature.
A
B
“B”
NUT
GENERAL TIGHTENING
TORQUES
N.m Kgf.m
4 mm
2.3 0.23
5 mm 4.5 0.45
6 mm
10 1.01
8 mm
25 2.54
10 mm
45 4.58
12 mm
80 8.15
14 mm
130 13.25
16 mm
200 20.39
18 mm
240 24.47
COPY - Moto GB - Grant Martland - grantmartland@motogb.co.uk

Benelli TRK 502 Specifications

General

Displacement	500 cc
Transmission	6-speed
Fuel Tank Capacity	20 liters
Seat Height	800 mm
Wet Weight	235 kg
Bore x Stroke	69 mm x 66.8 mm
Compression Ratio	11.5:1
Clutch	Wet multi-plate
Frame	Steel trellis
Wheelbase	1505 mm
Ground Clearance	190 mm
Max Power	47.6 hp (35 kW) @ 8500 rpm
Max Torque	46 Nm @ 6000 rpm
Front Suspension	50 mm upside-down fork
Front Brake	Double floating discs, 320mm, 4-piston calipers
Rear Brake	Single 260 mm disc
Fuel System	Electronic Fuel Injection (EFI)
ABS	Dual-channel ABS
Front Tire	120/70 R17
Rear Tire	160/60 R17
Engine Type	Liquid-cooled, four-stroke, parallel twin cylinder, DOHC, 4 valves per cylinder