3-178
Confidential
(4) Release the TT release clutch harness* from the securing fixtures. Remove the three
taptite bind B M4x12 screws. Remove the drive ASSY and pull out the TT release clutch
harness* through the hole.
(5) Remove the TT release clutch*, the TT gear Z20/Z44, and the idle gear 37.
Fig. 3-176
Note:
• The T2TT unit does not have the TT release clutch*.
TT gear Z20/Z44
TT release clutch*
Idle gear 37
Drive ASSY
Taptite bind B M4x12
Hole
TT release clutch harness*
* T3, T4, T5 only
To Next Page
Loading...
