Brother HL-5590DN

3-142
Confidential
11.8 MX bin stack sensor PCB ASSY
(1) Release each harness from the securing fixtures.
(2) Remove the two taptite bind B M3x10 screws, and remove the MX bin stack sensor holder
and the MX bin stack actuator. (4 places)
Fig. 3-135
Harness routing: Refer to “10. Left side of the MX”.
(3) Release the two hooks, and remove the MX bin stack sensor PCB ASSY from the MX
bin stack sensor holder. Disconnect the MX bin stack sensor harness from the MX bin
stack sensor PCB ASSY. (4 parts)
Fig. 3-136
MX 4bin stack sensor holder
MX bin stack actuator
MX 3bin stack sensor holder
MX 2bin stack sensor holder
MX 1bin stack
sensor holder
Taptite bind B M3x10
Hooks
MX bin stack sensor PCB ASSY
MX bin stack sensor harness
MX bin stack sensor holder