Capintec CRC-25R - PRINTING A RECORD OF THE MEASUREMENT

CAPINTEC, INC. CRC
®
-25R
PRINTING A RECORD OF THE MEASUREMENT
To print a record of the measurement, a printer must be set up as described in CHAPTER 5:
SYSTEM INITIALIZATION; SECTION: PRINTING.
Follow the directions below for the selected printer:
OKIDATA Printer
Ticket Chosen:
• If the printer is set up for continuous feed, press PARK (on printer).
• Move the right hand lever back to single-sheet.
• Place the ticket between the guides with CAPINTEC, INC down and facing away
from you. The ticket will automatically be advanced into the printer.
• Press the SEL pad on the printer so that the SEL light is lit.
• Input the User ID if desired.
• Press ENTER (on the readout).
Single Line Chosen:
• Input the User ID if desired.
• Press ENTER (on the readout).
Epson LX-300+II Printer
Ticket Chosen:
• If the printer is set up for continuous feed, press LOAD/EJECT (on printer).
• Move the paper release lever back to single-sheet.
• Slide the left edge guide until it locks in place at the guide mark.
• Adjust the right edge guide to match the width of the ticket.
• Insert the ticket between the guides with CAPINTEC, INC down and facing away
from you. The ticket will automatically be advanced into the printer.
• Input the User ID if desired.
• Press ENTER (on the readout).
Single Line Chosen:
• Input the User ID if desired.
• Press ENTER (on the readout).
Roll Printer
• Input the User ID if desired.
• Press ENTER (on the readout).
March 15 MEASUREMENT PROCEDURES 10 - 9