CAPINTEC, INC. CRC
®
-25R
ACCEPTANCE TESTING
The following tests should be performed prior to operational use of the unit.
Chamber Tests
Diagnostics Test
Reference CHAPTER 9: DIAGNOSTICS for instructions on how to perform this test.
Daily Test
Reference CHAPTER 8: BACKGROUND AND TESTS, SECTION: DAILY TEST for
instructions on how to perform this test.
Accuracy Test
Reference CHAPTER 8: BACKGROUND AND TESTS, SECTION: ACCURACY
TEST for instructions on how to perform this test.
OPERATIONAL SUMMARY
While all users the CRC
®
-25R are strongly encouraged to read the manual, we realize that
there are some who would much rather jump right in. If you are one of those people who say,
“if all else fails, read the manual”, then reference Appendix IV. These very simplified
instructions are intended to assist in getting you familiar with the basic operation of the
CRC
®
-25R. They are not intended to replace the detailed operating directions in the main
body of the manual.
WARNING
The General Operational Setup and Acceptance Testing sections above must be performed
before referring to Appendix IV. The steps described omit several important tests which may
be required by your license and which are also required in order to achieve the full accuracy
of the system. Samples measured without the complete start-up procedure having been
performed should not be administered to patients.
4 - 8 SYSTEM SETUP March 15
To Next Page
Loading...
Need help?
General