CAPINTEC, INC CRC
®
-25R
MAKING A KIT
A kit may be made from plain Tc99m in Inventory. To make a kit, select MAKE KIT from
Figure 12-2 Inventory Menu.
If there is no plain Tc99m stored in the Inventory,
Figure 12-14 No Plain Tc99m for Kits in
Inventory Screen
will appear.
NO Tc FOR KITS
IN IVENTORY
Any Key to continue
Figure 12-14 No Plain Tc99m for Kits in Inventory Screen
Press any key (except HOME) to continue.
Figure 12-2 Inventory Menu will re-appear.
If there is more than one plain Tc99m in the Inventory, a list showing the ID number (if one
was entered) will be displayed. Press the number corresponding to the desired Tc99m.
Note: When making a kit from the Inventory, the Readout Unit must be in the same units (Ci
or Bq) as the source was when added to the Inventory. If the selected item is in the
other units (Ci or Bq), the following error message will appear – “Ci/Bq MUST BE
SELECTED ON MAIN SCREEN TO WITHDRAW FROM ITEM ENTERED IN Ci/Bq –
ANY KEY TO CONTINUE”.
The details of the selected item will be displayed, showing the volume, current activity and
the current Mo to Tc ratio (unless the entered ratio was 0; if activity is very low, only Mo/Tc:
will be displayed without any value).
Press NO to make another selection (or return to the Inventory Menu if there is only one
Tc99m in inventory).
Press YES to use the selection.
Figure 12-15 Select Study for kit Screen will appear.
August 07 INVENTORY 12 - 7
To Next Page
Loading...