Capintec CRC-25R - MOLY ASSAY SETUP

To Next Page

To Previous Page

CAPINTEC, INC. CRC

-25R

CONSTANCY TEST

Co57

OK? Y OR N

Figure 6-16 Constancy Source Verification

If the displayed source is correct, press YES. Figure 6-5 Test Source Menu will re-appear.

If the displayed source is not correct, press NO. Figure 6-17 Constancy Test Source

Selection will appear. (In the example below, Co57 and Co60 are set to use as Daily

Sources.)

CONSTANCY TEST

1. Co57

2. Co60

Figure 6-17 Constancy Test Source Selection

Choose the Daily Test Source to be used for the Constancy Test. Figure 6-16 Constancy

Source Verification screen will re-appear.

MOLY ASSAY SETUP

Moly Assay can be performed using a CAPMAC or CANISTER.

When Moly Assay is chosen from the Test Menu (reference CHAPTER 10: MEASUREMENT

PROCEDURES, SECTION: MOLY ASSAY), Figure 6-18 Moly Assay Method Selection the

Moly Assay Method Selection screen will appear. However, if only one method is always

used (either a CAPMAC or a CANISTER), the Moly Assay Method Selection screen can be

omitted by selecting either CAPMAC or CANISTER from the Moly Setup in the Other Menu.

6 - 10 CHAMBER INITIALIZATION March 15