CAPINTEC, INC. CRC
®
-25R
o Epson Stylus C86 Inkjet (or equivalent) printer
The Printer should have the following accessories:
• Power Supply
• Printer Ribbon
• Communications Cable
• Roll Paper (If Roll printer ordered)
• Tickets (If Ticket printer ordered)
Note: If Test Sources are ordered, they will be shipped separately.
3. Be sure to remove all tape and protective material from the instrument prior to
connecting to the power line.
ASSEMBLY
Figure 4-1
1. Verify that all power switches (Readout and Printer) are in the “OFF” or “0” position.
Note: If using the Slip-Ticket printer, please unplug from AC Power.
2. Connect the Chamber Cable to the connector at the rear of the CRC
®
-25R Readout
labeled “CHAMBER”.
4 - 2 SYSTEM SETUP March 15
To Next Page
Loading...