CAPINTEC, INC. CRC
®
-25R
After choosing the desired setting, Figure 5-6 Ci / Bq Verification Screen will re-appear
showing the new selection.
If 1 was pressed, the Verification Screen will display: FIXED TO Ci.
If 2 was pressed, the Verification Screen will display: FIXED TO Bq.
If 3 was pressed, the Verification Screen will display: Ci / Bq Selectable.
If the displayed setting is correct, press YES. Figure 5-2 Main Setup Menu will re-appear.
If the displayed setting is not correct, press NO. Figure 5-7 Ci / Bq Selection Screen will re-
appear.
PRINTING
CAUTION: If any printer other than one of the models supplied by Capintec is used,
Electromagnetic Interference (EMI) may be introduced into other devices
located in the same general area as the CRC
®
The CRC
®
-25R may be used with the following printers:
• RS-232 printers
o Okidata Microline 320
o Epson LX-300+II
o Epson TM-295II Slip printer
o Epson TM-U220D Roll printer
• USB printers
o HP DeskJet 6000/8000 Series Inkjet (or equivalent) printer
o Epson Stylus C86 Inkjet (or equivalent) printer
Printer Power Requirements
Okidata Microline 320 printer (optional)
120Vac, 60Hz or
230/240Vac, 50/60Hz
Epson LX-300+II printer (optional)
99-132Vac, 50/60Hz, 0.6A (maximum 1.4A depending on the character type)
198-264Vac, 50/60Hz, 0.3A (maximum 1.4A depending on the character type)
Epson TM-295II Slip Printer (optional)
Input: 100-240Vac, 50/60Hz, 1.2A; Output: +24Vdc, 0.8A
Epson TM-U220D Roll Printer (optional)
Input: 100-240Vac, 50/60Hz, 1.0A max; Output: 24Vdc, 1.5A
HP DeskJet 6000/8000 Series Inkjet (or equivalent) Printer (optional)
100-240Vac, 50/60Hz, 1.5A
5 - 4 SYSTEM INITIALIZATION March 15
To Next Page
Loading...
Need help?
General