EasyManua.ls Logo

CipherLab 1663 Series - Page 36

CipherLab 1663 Series
235 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
24
Enter Setup
1663 Barcode Scanner User Guide
After establishing a WPAN connection successfully
1) Once a WPAN connect ion is established successfully, t he scanner will st ay active for a specified
period of tim e (2 m inutes by default ) for dat a transm ission. I ts CPU is running at full speed,
and the LED is flashing blue ( On/ Off ratio 0.02 s: 3 s) .
2) I f it is idle wit hin 2 m inutes, the scanner will become inact ive to save power for t he rem aining
period of tim e (t he specified value m inus 2 m inutes). I t s CPU is running at low speed, and t he
LED is flashing red ( On/ Off ratio 0.3 s: 2.5 s) .
Press t he [ Trigger] key to wake up the scanner when it becom es inact ive, and the scanner will
st ay active again.
3) I f it is idle and finally stays inactive unt il the specified tim e interval for Auto Power Off has
elapsed, the scanner will autom at ically turn off in order to conserve bat tery power. The three
short beeps will ring out , t one descending from high to low.
Hold down t he [ Power/ Delete] key for 2 seconds to t urn it on.
For Bluetoot h
®
HI D, the scanner will resum e connection with the host upon powering on
again, as long as the host applicat ion is running. The three short beeps will ring out, t one
ascending from low t o high. I f the scanner fails to resum e connection, it will try every 5
seconds to re- connect to t he host unless the Reset Connect ion barcode has been
scanned.
For Bluetooth
®
SPP Slave Mode, the scanner must wait for the host to re- connect.
For Bluet ooth
®
SPP Mast er Mode, t he scanner will resum e connection with the host upon
powering on again, as long as the host application is running. The three short beeps will
ring out , tone ascending from low t o high. I f the scanner fails to resum e connection, it will
try every 5 seconds to re- connect to t he host unless the Reset Connect ion or Restore
System Defaults barcode has been scanned.
With the use of 3610, the scanner will try re- connect ing to 3610 whilst the scanner is
active.

Table of Contents

Related product manuals