25
Update
Chapter 1
Understandin
he Barcode Scanner
Auto Off after
0~254 min. (*10)
1) Read t he barcode above t o specify t he t im e interval in m inutes before the scanner
automat ically turns off.
2) Read t he “
Decimal Value” barcode on page 219. For exam ple, read “1” and “5” for t he
scanner to autom at ically t urn off after being idle for 15 m inutes.
3) Read t he “ Validat e” barcode on t he sam e page t o com plet e t his set t ing.
Not e: Aut o Power Off will not t ake effect when the scanner is in the configuration m ode.
Power-
aving after
0~254 min. (*2)
1) Read t he barcode above t o specify t he t im e interval in m inutes before the scanner
enters low- speed m ode.
2) Read t he “
Decim al Value” barcode on page 219. For exam ple, read “5” for the
scanner to enter low- speed mode aft er being idle for 5 m inut es.
3) Read t he “ Validat e” barcode on t he sam e page t o com plet e t his set t ing.
Not e: Power- Saving will not take effect when one of t he following condit ions is m et :
(1) The scanner has already established a BT HI D/ SPP connect ion.
(2) The scanner is in the configuration mode.
(3) The scan mode is set to Test, Continuous or Alternate Mode.
(4) The sett ing value of Power-Saving is great er than that of Aut o Power Off.
To Next Page
Loading...
