Send documentation comments to mdsfeedback-doc@cisco.com
Contents
xvii
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
OL-9285-05
IP Issues 20-5
Verifying Basic Connectivity 20-5
Verifying Basic Connectivity Using Device Manager 20-5
Verifying Basic Connectivity Using the CLI 20-5
Verification of Switch Connectivity 20-7
Verifying Switch Connectivity Using Fabric Manager 20-7
Verifying Switch Connectivity Using the CLI 20-7
Verification of Static IP Routing 20-8
Verifying Static IP Routing Using Device Manager 20-8
Verifying Static IP Routing Using the CLI 20-8
Cannot Assign IP Address to an Interface 20-9
FCIP Issues 20-9
One-to-One FCIP Tunnel Creation and Monitoring 20-10
Configuring the First Switch with the CLI 20-10
Displaying the Default Values Using the CLI 20-11
Setting the Static Route for FCIP Tunnels Using the CLI 20-11
Debugging the Configuration of the Second Switch Using the CLI 20-11
Displaying the Debug Output from FCIP Tunnel Supervisor Using the CLI 20-13
Displaying the Debug Output from the FCIP Tunnel IPS Module Using the CLI 20-14
Verifying the Configuration of the Profiles Using the CLI 20-15
Verifying the Establishment of the FCIP Tunnel Using the CLI 20-15
Verifying the Establishment of Default TCP Connections for Each Configured FCIP Tunnel Using
the CLI 20-17
Verifying the Statistics of the ASIC Chip on Each Gigabit Ethernet Port Using the CLI 20-17
Ethereal Screen Captures of the TCP Connection and FCIP Tunnels 20-18
One-to-Three FCIP Tunnel Creation and Monitoring 20-20
Displaying the Configuration of the First Switch Using the CLI 20-20
Creating the FCIP Interface for the Second Tunnel Using the CLI 20-21
FCIP Profile Misconfiguration Examples 20-21
Displaying Incorrect or Nonexistent IP Address for an FCIP Profile Using the CLI 20-21
Displaying Configuration Errors When Bringing Up a Tunnel on a Selected Port Using the
CLI 20-22
FCIP Interface Misconfiguration Examples 20-24
Displaying FCIP Misconfiguration Examples Using the CLI 20-24
Displaying the FCIP Interface as Administratively Shut Down Using the CLI 20-25
Displaying the Debug Output from the Second Switch Using the CLI 20-26
Displaying Passive Mode Set on Both Sides of the FCIP Tunnel with the CLI 20-27
Displaying a Time Stamp Acceptable Difference Failure Using the CLI 20-28
FCIP Special Frame Tunnel Creation and Monitoring 20-30
Configuring and Displaying an FCIP Tunnel with Special Frame Using the CLI 20-31
To Next Page
Loading...
Need help?
General