Cisco ASR 9000 Series - L2 Transport Service-Policy

l2transport service-policy
To configure a Layer 2 transport quality of service (QoS) policy, use the l2transport service-policy command
in interface configuration mode. To return to the default behavior, use the no form of this command.
l2transport service-policy {input policy-name| output policy-name}
no l2transport service-policy {input policy-name| output policy-name}
Syntax Description
Configures the direction of service policy application: input.
input policy-name
Configures the direction of service policy application: output.
output policy-name
Command Default
None
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writel2vpn
read, writeatm
Examples
The following example shows how configure an L2 transport quality of service (QoS) policy:
RP/0/RSP0RP00/CPU0:router# configure
RP/0/RSP0RP00/CPU0:router(config)# interface GigabitEthernet 0/0/0/0
RP/0/RSP0RP00/CPU0:router(config-if)# l2transport service-policy input sp_0001
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
98
Point to Point Layer 2 Services Commands
l2transport service-policy