Cisco ASR 9000 Series Reference Guide

evi (PBB)
To enable PBB EVPN and set the EVI for the bridge, use the evi command in the L2VPN bridge group bridge
domain PBB-core configuration mode. To disable PBB EVPN and reset the EVI, use the no form of this
command.
evi evi-id
no evi evi-id
Syntax Description
Specifies the Ethernet VPN ID to set. The range is from 1 to 65534.
evi-id
Command Default
None.
Command Modes
L2VPN bridge group bridge domain PBB core configuration
Command History
ModificationRelease
This command was introduced.Release 4.3.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The VPN ID must be unique globally per network.
Task ID
OperationTask ID
read, writel2vpn
Examples
This example shows how to enable PBB EVPN and set the EVI for the bridge:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# bridge group 1
RP/0/RSP0/CPU0:router(config-l2vpn-bg)# bridge-domain 1
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# pbb core
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-pbb-core)# evi 2
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-pbb-core)#
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
402
Provider Backbone Bridge Commands
evi (PBB)

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model