transport mode vlan passthrough
To configure L2VPN bridge domain transport mode, use the transport mode vlan passthrough command
in L2VPN bridge domain configuration mode. To disable the L2VPN bridge domain transport mode
configuration, use the no form of this command.
transport mode vlan passthrough
no transport mode vlan passthrough
Syntax Description
This command has no keywords or arguments.
Command Default
None
Command Modes
L2VPN bridge domain configuration
Command History
ModificationRelease
This command was introduced.Release 4.3.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
All L2VPN configurations can be deleted using the no l2vpn command.Note
Task ID
OperationsTask ID
read, writel2vpn
Examples
This example shows how to configure transport mode vlan passthrough:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# bridge group bg1
RP/0/RSP0/CPU0:router(config-l2vpn-bg)# bridge-domain bd1
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# transport mode vlan passthrough
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
223
Point to Point Layer 2 Services Commands
transport mode vlan passthrough
To Next Page
Loading...
Need help?
General
