Cisco ASR 9000 Series Reference Guide

logging nsr
To enable non-stop routing logging, use the logging nsr command in L2VPN configuration submode. To
return to the default behavior, use the no form of this command.
logging nsr
no logging nsr
Syntax Description
This command has no keywords or arguments.
Command Default
None
Command Modes
L2VPN configuration submode
Command History
ModificationRelease
This command was introduced.Release 4.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
All L2VPN configuration can be deleted using the no l2vpn command.Note
Task ID
OperationsTask ID
read, writel2vpn
Examples
The following example shows how to enable non-stop routing logging:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# logging nsr
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
108
Point to Point Layer 2 Services Commands
logging nsr

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model