max age
To set the maximum age for BPDUs sent on this interface, use the max age command in MSTAG interface
configuration, REPAG interface configuration, PVSTAG VLAN configuration, or PVRSTAG VLAN
configuration submode.
max age seconds
Syntax Description
Maximum age time for the bridge in seconds. Range is 6 to 40.
seconds
Command Default
seconds: 20
Command Modes
MSTAG interface configuration, REPAG interface configuration, PVSTAG VLAN configuration, PVRSTAG
VLAN configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.1
This command was supported in the PVSTAG VLAN and PVRSTAG
VLAN configuration modes.
Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeethernet-services (PVSTAG and PVRSTAG only)
read, writeinterface (MSTAG and REPAG only)
Examples
The following example shows how to set the maximum age time for the bridge to 20:
RP/0/RSP0/CPU0:router(config-mstag-if)# max age 20
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
539
Multiple Spanning Tree Protocol Commands
max age
To Next Page
Loading...
Need help?
General
