Cisco ASR 9000 Series Reference Guide

load-balancing flow
To enable all bundle EFPs and PW to use either L2 flow based or L3 flow based balancing, use the
load-balancing flow command in L2VPN configuration mode.
load-balancing flow [src-dst-mac| src-dst-ip]
Syntax Description
Enables global flow load balancing hashed on source and destination MAC
addresses.
src-dst-mac
Enables global flow load balancing hashed on source and destination IP
addresses.
src-dst-ip
Command Default
The default load balancing is based on the source and destination MAC addresses.
Command Modes
L2VPN configuration
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writel2vpn
Examples
The following example shows how to set the L3 flow based load balancing:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# load-balancing flow src-dst-ip
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
102
Point to Point Layer 2 Services Commands
load-balancing flow

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model