Cisco ASR 9000 Series - Ethernet Interfaces Commands

Ethernet Interfaces Commands
This module describes the Cisco IOS XR software commands used to configure the Ethernet interfaces on
the Cisco ASR 9000 Series Router.
This module does not include the commands for Management Ethernet interfaces and Ethernet OAM. To
configure a Management Ethernet interface for routing or modify the configuration of a Management
Ethernet interface or to configure Ethernet OAM, use the commands described in the Cisco ASR 9000
Series Aggregation Services Router Interface and Hardware Component Configuration Guide
Note
Refer to the Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component
Command Reference for more information on the Ethernet Interfaces and Ethernet OAM commands.
•
dot1q tunneling ethertype, page 2
•
encapsulation default, page 4
•
encapsulation dot1ad dot1q, page 6
•
encapsulation dot1q, page 8
•
encapsulation dot1q second-dot1q, page 10
•
encapsulation untagged, page 12
•
ethernet egress-filter, page 14
•
ethernet filtering, page 16
•
ethernet source bypass egress-filter, page 20
•
l2protocol (Ethernet), page 21
•
l2transport (Ethernet), page 23
•
local-traffic default encapsulation, page 26
•
rewrite ingress tag, page 28
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
1