sequencing (L2VPN)
To configure L2VPN pseudowire class sequencing, use the pw-class sequencing command in L2VPN
pseudowire class encapsulation mode. To return to the default behavior, use the no form of this command.
sequencing {both| receive| transmit {resynch 5-65535}}
no sequencing {both| receive| transmit {resynch 5-65535}}
Syntax Description
Configures transmit and receive side sequencing.both
Configures receive side sequencing.receive
Configures transmit side sequencing.transmit
Configures the threshold for out-of-sequence packets before
resynchronization. Range is 5 to 65535.
resynch 5-65535
Command Default
None
Command Modes
L2VPN pseudowire class encapsulation mode
Command History
ModificationRelease
This command was introduced.Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Do not configure sequence resynch on high speed circuits. On low speed circuits, do not configure a threshold
lower than 10 to 20 seconds of traffic.
This command is not supported on the Cisco ASR 9000 Series Aggregation Services Router.Note
All L2VPN configurations can be deleted using the no l2vpn command.Note
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
138
Point to Point Layer 2 Services Commands
sequencing (L2VPN)
To Next Page
Loading...
Need help?
General
