Cisco ASR 9000 Series Reference Guide

vlan
To enable a PVST or PVRST VLAN instance on the interface and enter PVSTAG or PVRSTAG VLAN
configuration mode, use the vlan command in PVSTAG or PVRSTAG configuration submode.
vlan vlan-id
Syntax Description
Specifies the VLAN identifier. The range of the VLAN ID is between 1 to 4094.
There is a limit of 200 VLANs per physical interface and 16000 VLANs across
the system.
Note
vlan-id
Command Default
None
Command Modes
PVRSTAG interface configuration, PVSTAG interface configuration
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeethernet-services
Examples
The following example shows how to enable a VLAN in the PVSTAG configuration mode:
RP/0/RSP0/CPU0:router(config)# spanning-tree pvstag A
RP/0/RSP0/CPU0:router(config-pvstag)# interface GigabitEthernet 0/3/03
RP/0/RSP0/CPU0:router(config-pvstag-if)# vlan 100
RP/0/RSP0/CPU0:router(config-pvstag-if-vlan)#
Related Commands
DescriptionCommand
Enables packet debugging for sent and received PVRSTAG
packets.
debug spanning-tree pvrstag packet, on
page 489
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
639
Multiple Spanning Tree Protocol Commands
vlan

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model