Cisco ASR 9000 Series Reference Guide

peering
To configure the peering timer, use the peering command in the EVPN Timers configuration mode. To delete
the peering timer, use the no form of this command.
peering seconds
no peering seconds
Syntax Description
Specifies the value in seconds ranging from 0 to 300 seconds. The default value
is 45 seconds.
seconds
Command Default
None.
Command Modes
EVPN Timers configuration
Command History
ModificationRelease
This command was introduced.Release 4.3.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
In a single homed Ethernet segment, wait for this timer to expire before advertising BGP route target, Ethernet
segment identifier (ESI), and local MAC.
Task ID
OperationTask ID
read, writel2vpn
Examples
This example shows how to configure the peering timer in the EVPN Timers configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# evpn
RP/0/RSP0/CPU0:router(config-evpn)# timers
RP/0/RSP0/CPU0:router(config-evpn-timers)# peering 30
RP/0/RSP0/CPU0:router(config-evpn-timers)#
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
422
Provider Backbone Bridge Commands
peering

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model