Cisco ASR 9000 Series - Ethernet-Segment

ethernet-segment
To enter the EVPN interface ethernet segment configuration mode, use the ethernet-segment command in
the EVPN interface configuration mode. To disable the Ethernet segment configuration, use the no form of
this command.
ethernet-segment [backbone-source-mac | identifier | load-balancing-mode | service-carving]
no ethernet-segment [backbone-source-mac | identifier | load-balancing-mode | service-carving]
Syntax Description
Specifies Backbone Source MAC.backbone-source-mac
Specifies Ethernet Segment Identifier.identifier
Specifies load balancing mode.load-balancing-mode
Specifies service carving.service-carving
Command Default
None.
Command Modes
EVPN interface configuration
Command History
ModificationRelease
This command was introduced.Release 4.3.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
read, writel2vpn
Examples
This example shows how to enter the EVPN interface ethernet segment configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# evpn
RP/0/RSP0/CPU0:router(config-evpn)# interface bundle-ether 1
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
396
Provider Backbone Bridge Commands
ethernet-segment