Cisco ASR 9000 Series - P2 P

p2p
To enter p2p configuration submode to configure point-to-point cross-connects, use the p2p command in
L2VPN xconnect mode. To return to the default behavior, use the no form of this command.
p2p xconnect-name
no p2p xconnect-name
Syntax Description
(Optional) Configures the name of the point-to-point cross- connect.
xconnect-name
Command Default
None
Command Modes
L2VPN xconnect
Command History
ModificationRelease
This command was introduced.Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The name of the point-to-point cross-connect string is a free format description string.
Task ID
OperationsTask ID
read, writel2vpn
Examples
The following example shows a point-to-point cross-connect configuration (including pseudowire
configuration):
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# xconnect group group 1
RP/0/RSP0/CPU0:router(config-l2vpn-xc)# p2p xc1
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
134
Point to Point Layer 2 Services Commands
p2p