recovery
To configure the recovery timer, use the recovery command in the EVPN Interface Timers configuration or
in the EVPN Timers configuration mode. To delete the recovery timer, use the no form of this command.
recovery seconds
no recovery seconds
Syntax Description
Specifies the value in seconds ranging from 20 to 3600 seconds. The default value
is 20 seconds.
seconds
Command Default
None.
Command Modes
EVPN Interface Timers configuration
EVPN Timers configuration
Command History
ModificationRelease
This command was introduced.Release 4.3.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
This timer is used to wait before processing the port state UP event in order to give the CE running STP to
converge. If the interface is up and all conditions are already met, this timer is skipped to not add any more
delays.
Task ID
OperationTask ID
read, writel2vpn
Examples
This example shows how to configure the recovery timer in the EVPN Interface Timers configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# evpn
RP/0/RSP0/CPU0:router(config-evpn)# interface bundle-ether 1
RP/0/RSP0/CPU0:router(config-evpn-ac)# timers
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
427
Provider Backbone Bridge Commands
recovery
To Next Page
Loading...
Need help?
General
