Cisco ASR 9000 Series Reference Guide

xconnect group
To configure cross-connect groups, use the xconnect group command in L2VPN configuration mode. To
return to the default behavior, use the no form of this command.
xconnect group group-name
no xconnect group group-name
Syntax Description
Configures a cross-connect group name using a free-format 32-character
string.
group-name
Command Default
None
Command Modes
L2VPN configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
You can configure up to a maximum of 16K cross-connects per box.Note
Task ID
OperationsTask ID
read, writel2vpn
Examples
The following example shows how to group all cross -connects for customer_atlantic:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# xconnect group customer_atlantic
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
227
Point to Point Layer 2 Services Commands
xconnect group

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model