Cisco ASR 9000 Series Reference Guide

interface (p2p)
To configure an attachment circuit, use the interface command in p2p configuration submode. To return to
the default behavior, use the no form of this command.
interface type interface-path-id [PW-Ether | PW-IW]
no interface type interface-path-id [PW-Ether | PW-IW]
Syntax Description
Interface type. For more information, use the question mark (?) online help function.
type
Physical interface or a virtual interface.
Use the show interfaces command to see a list of all possible interfaces
currently configured on the router.
Note
For more information about the syntax for the router, use the question mark (?)
online help function.
interface-path-id
(Optional) Configures an Ethernet Interface.PW-Ether
(Optional) Configures an IP Interworking Interface.PW-IW
Command Default
None
Command Modes
p2p configuration submode
Command History
ModificationRelease
This command was introduced.Release 3.7.2
The following keywords were added:
•
PW-Ether
•
PW-IW
Release 4.2.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
83
Point to Point Layer 2 Services Commands
interface (p2p)

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model