port-priority
To set the port priority performance parameter for the MSTI, use the port-priority command in MSTAG
instance configuration, REPAG instance configuration, PVSTAG VLAN configuration, or PVRSTAG VLAN
configuration submode.
port-priority priority [startup-value startup-priority]
Syntax Description
Port priority. For MSTAG, REPAG and PVRSTAG, the range is between 0
to 40 in multiples of 16. For PVSTAG, the range is between 0 to 255.
priority
Specifies an alternate value to use when the interface first comes up, while the
preempt delay timer is running.
startup-value
Sets the startup port priority.
startup-priority
Command Default
If no startup-value is configured, the normal value is used during startup.
Command Modes
MSTAG instance configuration, REPAG instance configuration, PVSTAG VLAN configuration, PVRSTAG
VLAN configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.1
This command was supported in the PVSTAG VLAN and PVRSTAG
VLAN configuration modes.
Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeethernet-services (PVSTAG and PVRSTAG only)
read, writeinterface (MSTAG and REPAG only)
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
556
Multiple Spanning Tree Protocol Commands
port-priority
To Next Page
Loading...
Need help?
General
