Cisco ASR 9000 Series - Neighbor Routed

neighbor routed
To enable pseudowire routing configuration submode for the p2p cross-connect, use the neighbor routed
command in the p2p configuration submode.
neighbor routed global-id:prefix:ac-id source ac-id
Syntax Description
Targeted remote autonomous system number.
global-id
Targeted remote PE IP address.
prefix
Specifies the targeted remote attachment circuit id.
ac-id
Specifies the local attachment circuit ID.
source ac-id
Command Default
None
Command Modes
p2p configuration submode
Command History
ModificationRelease
This command was introduced.Release 5.1.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
read, writel2vpn
Examples
The following example shows how to enable pseudowire routing configuration submode for the p2p
cross-connect.
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# xconnect group pw-he1
RP/0/RSP0/CPU0:router(config-l2vpn-xc)# p2p pw-ss
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# interface gigabitethernet 0/1/0/9
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# neighbor routed 100:2.2.2.2:10 source 10
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p-pwr)# pw-class dynamic_sspw
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
118
Point to Point Layer 2 Services Commands
neighbor routed