ethernet ring g8032 profile
To configure G.8032 ring profile and to enter the G.8032 ring profile configuration mode, use the ethernet
ring g8032 profilecommand in the global configuration mode. To disable the G.8032 ring profile, use the no
form of this command.
ethernet ring g8032 profile profile-name [non-revertive| timer {guard milliseconds| hold-off seconds| wtr
minutes }]
Syntax Description
Configures non-revertive ring instance.non-revertive
Configures G.8032 timer.timer
Configures G.8032 guard timer. The Guard timer can be configured and
the default time interval is 500 ms. The time interval ranges from 10 to
2000 ms.
guard
Configures G.8032 hold-off timer. The hold-off timer can be configured
and the default time interval is 0 seconds. The time interval ranges from
0 to 10 seconds.
hold-off
Configures G.8032 WTR timer. The WTR timer can be configured by the
operator, and the default time interval is 5 minutes. The time interval ranges
from 1 to 12 minutes.
wtr
Command Default
None
Command Modes
Command History
ModificationRelease
This command was introduced.Release 4.1.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
read, writeethernet-services
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
253
Multipoint Layer 2 Services Commands
ethernet ring g8032 profile
To Next Page
Loading...
Need help?
General
