EasyManuals Logo

Cisco ASR 9000 Series Reference Guide

Cisco ASR 9000 Series
696 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #289 background imageLoading...
Page #289 background image
limit (VPLS)
To set the MAC address limit for action, maximum, and notification and to enter L2VPN bridge group bridge
domain MAC limit configuration mode, use the limit command in L2VPN bridge group bridge domain MAC
configuration mode. To remove all limits that were previously configured under the MAC configuration
submodes, use the no form of this command.
limit
no limit
Syntax Description
This command has no keywords or arguments.
Command Default
None
Command Modes
L2VPN bridge group bridge domain MAC configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the limit command to enter L2VPN bridge group bridge domain MAC limit configuration mode. The
limit command specifies that one syslog message is sent or a corresponding trap is generated with the MAC
limit when the action is violated.
Task ID
OperationsTask ID
read, writel2vpn
Examples
The following example shows how the MAC limit for the bridge bar is set to 100 with an action of shutdown.
After the configuration, the bridge stops all forwarding after 100 MAC addresses are learned. When this
happens, a syslog message and an SNMP trap are created.
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# bridge group 1
RP/0/RSP0/CPU0:router(config-l2vpn-bg)# bridge-domain bar
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# mac
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
275
Multipoint Layer 2 Services Commands
limit (VPLS)

Table of Contents

Other manuals for Cisco ASR 9000 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR 9000 Series and is the answer not in the manual?

Cisco ASR 9000 Series Specifications

General IconGeneral
SeriesASR 9000
CategoryNetwork Router
Modular DesignYes
RedundancyYes (Hardware and Software)
Operating SystemCisco IOS XR
Interfaces/Ports10G, 40G, 100G, 400G Ethernet
Expansion SlotsVaries by model
Routing ProtocolBGP, OSPF, IS-IS, EIGRP
ManagementCLI, SNMP, NETCONF
Power SupplyRedundant
Port DensityVaries by model
Power Supply OptionsAC, DC
MemoryVaries by model
StorageVaries by model
DimensionsVaries by model
WeightVaries by model

Related product manuals