Cisco ASR 9000 Series Reference Guide

interface nve
To create a network virtualization endpoint (NVE) interface and enter the NVE interface configuration mode,
use the interface nve command in Global Configuration mode. To remove the NVE interface, use the no
form of this command.
interface nve nve-id
Syntax Description
The NVE interface ID. It can take values from 1 to 65535.
nve-id
Command Default
None
Command Modes
Global Configuration
Command History
ModificationRelease
This command was introduced.Release 5.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
read, writeinterface
Examples
The following example shows how to create an NVE interface and enter the NVE interface configuration
mode.
RP/0/RSP0/CPU0:router(config)# interface nve 1
RP/0/RSP0/CPU0:router(config-if)#
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
673
VXLAN Commands
interface nve

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model