Cisco ASR 9000 Series - Show Spanning-Tree Pvrstag

show spanning-tree pvrstag
To display the values currently used for populating the BPDUs sent by all ports (with the specified feature
enabled), use the show spanning-tree pvrstag in the EXEC mode.
show spanning-tree pvrstag protocol instance identifier [interface type interface-path-id]
Syntax Description
String of a maximum of 25 characters that identifies the protocol instance.
protocol instance identifier
Interface type. For more information, use the question mark (?) online help
function.
interface type
Physical interface or virtual interface.
Use the show interfaces command to see a list of all interfaces
currently configured on the router.
Note
For more information about the syntax for the router, use the question mark
(?) online help function.
interface-path-id
Command Default
None
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
readinterface
Examples
The following example shows the output from the show spanning-tree pvrstag command:
RP/0/RSP0/CPU0:router# show spanning-tree pvrstag interface GigabitEthernet0/0/0/1
GigabitEthernet0/0/0/1
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
613
Multiple Spanning Tree Protocol Commands
show spanning-tree pvrstag