inclusion-list
To associate a set of VLAN IDs with the current instance, use the inclusion-list command in the Ethernet
ring G.8032 instance configuration submode. To disassociate the VLAN IDs with the current instance, use
the no form of this command.
inclusion-list vlan-idsvlan-id
no inclusion-list vlan-idsvlan-id
Syntax Description
Associates a set of VLAN IDs with the current instance.vlan-ids
List of VLAN IDs in the form vlan-id <vlan range>[,<vlan range][,<vlan
range>][,<vlan range>].
vlan-id
Command Default
None
Command Modes
Ethernet ring G.8032 instance configuration submode
Command History
ModificationRelease
This command was introduced.Release 4.1.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
read, writel2vpn
Examples
This example shows how to associate VLAN IDs with instance 1:
RP/0/RSP0/CPU0:router#configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# ethernet ring g8032 r1
RP/0/RSP0/CPU0:router(config-l2vpn-erp)# instance 1
RP/0/RSP0/CPU0:router(config-l2vpn-erp-instance)# description test
RP/0/RSP0/CPU0:router(config-l2vpn-erp-instance)# profile p1
RP/0/RSP0/CPU0:router(config-l2vpn-erp-instance)# rpl port0 neighbor
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
263
Multipoint Layer 2 Services Commands
inclusion-list
To Next Page
Loading...
