notification (VPLS)
To specify the type of notification that is sent when the number of learned MAC addresses exceeds the
configured limit, use the notification command in L2VPN bridge group bridge domain MAC limit configuration
mode. To use the notification as only a syslog entry, use the no form of this command.
notification {both| none| trap}
no notification {both| none| trap}
Syntax Description
Sends syslog and trap notifications when the action is violated.both
Specifies no notification.none
Sends trap notifications when the action is violated.trap
Command Default
By default, only a syslog message is sent when the number of learned MAC addresses reaches the maximum
configured.
Command Modes
L2VPN bridge group bridge domain MAC limit configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
A syslog message and an SNMP trap is generated. Alternatively, an SNMP trap is generated. Finally, no
notification is generated.
Task ID
OperationsTask ID
read, writel2vpn
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
295
Multipoint Layer 2 Services Commands
notification (VPLS)
To Next Page
Loading...
Need help?
General
