Cisco ASR 9000 Series - Revision (MSTAG;REPAG)

revision (MSTAG/REPAG)
To set the revision level in the BPDUs sent from this interface, use the revision command in MSTAG or
REPAG interface configuration submode.
revision revision-number
Syntax Description
Revision level of the MSTP region. Range is 0 to 65535.
revision-number
Command Default
revision-number: 0
Command Modes
MSTAG interface configuration, REPAG interface configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeinterface
Examples
The following example shows how to set the revision level of the MSTP region to 1:
RP/0/RSP0/CPU0:router(config-mstag-if)# revision 1
Related Commands
DescriptionCommand
Enables MSTAG packet debugging.debug spanning-tree mstag packet, on page
483
Enables Resilient Ethernet Protocol (REP) Access Gateway
debugging commands.
debug spanning-tree repag packet, on page
493
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
569
Multiple Spanning Tree Protocol Commands
revision (MSTAG/REPAG)