Cisco ASR 9000 Series Reference Guide

transmit (PVRST)
To set the transmit hold count performance parameter, use the transmit command in PVRST configuration
submode. To undo the setting, use the no form of this command.
transmit hold-count count
no transmit hold-count count
Syntax Description
Specifies the hold count performance parameter
of the bridge.
hold-count
Bridge transmit hold count. The range is from 1
to 10.
count
Command Default
None
Command Modes
PVRST configuration
Command History
ModificationRelease
This command was introduced.Release 5.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeethernet-services
Examples
This example shows how to set the bridge transmit hold-count parameter to 8:
RP/0/RSP0/CPU0:router(config)# spanning-tree pvrst st1
RP/0/RSP0/CPU0:router(config-pvrst)# transmit hold-count 8
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
635
Multiple Spanning Tree Protocol Commands
transmit (PVRST)

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model