mac-flush mvrp
To perform a MAC flush on an Ethernet-segment, use the mac-flush command in the EVPN interface
configuration mode. To disable the MAC flush setting, use the no form of this command.
mac-flush mvrp
no mac-flush mvrp
Syntax Description
Specifies the MAC flush over MVRP.mvrp
Command Default
STP-TCN
Command Modes
EVPN interface configuration
Command History
ModificationRelease
This command was introduced.Release 4.3.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
read, writel2vpn
Examples
This example shows how to perform the MAC flush over MVRP on an Ethernet segment:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# evpn
RP/0/RSP0/CPU0:router(config-evpn)# interface bundle-ether 1
RP/0/RSP0/CPU0:router(config-evpn-ac)# mac-flush mvrp
RP/0/RSP0/CPU0:router(config-evpn-ac)#
Related Commands
DescriptionCommand
Enters the EVPN Interface configuration mode.interface (EVPN), on page 410
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
418
Provider Backbone Bridge Commands
mac-flush mvrp
To Next Page
Loading...
Need help?
General
