clear l2vpn bridge-domain (VPLS)
To clear the MAC addresses and to restart the bridge domains on the router, use the clear l2vpn bridge-domain
command in EXEC mode.
clear l2vpn bridge-domain {all| bd-name name| group group}
Syntax Description
Clears and restarts all the bridge domains on the router.all
Clears and restarts the specified bridge domain. The name argument specifies
the name of the bridge-domain.
bd-name name
Clears and restarts all the bridge domains that are part of the bridge group.
group group
Command Default
None
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
This is the method that allows a bridge to forward again after it was put in Shutdown state as a result of
exceeding the configured MAC limit.
Task ID
OperationsTask ID
read, writel2vpn
Examples
The following example shows how to clear all the MAC addresses and to restart all the bridge domains on
the router:
RP/0/RSP0/CPU0:router# clear l2vpn bridge-domain all
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
244
Multipoint Layer 2 Services Commands
clear l2vpn bridge-domain (VPLS)
To Next Page
Loading...
Need help?
General
